Matters needing attention in the use of Jianwei electric operating table

Date of release:2018-07-31 Author: Click:

1. The electric power into the operating table is a permanent device. The power output line must be pulled out of the three sockets with grounding wires in the medical institution after the event, so as to fully ground and ground the shell, which can effectively prevent the occurrence of electric shock due to excessive leakage current; it can also effectively prevent the accumulation of static electricity, friction and ignition, and cause the risk of explosion in the environment with anesthetic gas in the operating room The potential electromagnetic interference between the standby may affect each other or the occurrence of accidents.

2. The operation of electricity into the operating table should be stopped by the medical personnel trained by the consumer manufacturer. After the adjustment of the electricity into the operating table, it is necessary to put the hand-held operator in the center that the medical personnel should not contact to prevent misoperation, causing the electricity to move or turn into the operating table, resulting in the patient's accidental injury again and reducing the disease condition.

3. In use, if the network power supply is cut off, the emergency battery power supply can be used.

4. The power source, electric push rod and pneumatic spring should be sealed in the hidden parts. When repairing and self-examination, please do not assemble the external parts at will, so as to avoid affecting the normal use.

5. Replacement of fuse: please contact the manufacturer, do not use too large or too small melting apparatus.

6. Cleaning and disinfection: at the end of each operation, clean and disinfect the operating table pad.

7. At the end of each operation, the electric power should be put into the operating table to a certain degree (pay special attention to the leg board should be raised) and then lowered to the extremely low position. The power plug should be pulled out, so that the front zero line is double cut off and separated from the overall power supply of the network

8. Please read the instructions carefully before using this product.